Viconics VST5000 (Classic ZigBee) User Guide Manual do Utilizador descarregar pdf (Página 5)

VST5000W5000W Wireless Survey Tools User Guide

isdesignedforoptimalhorizontaldistance

penetration.Holdingthesurveytoolorthecontroller

horizontallywilldramaticallylowertherangeof

connectivity.

• Holdthesurveytoolatthelocationwhereyouwould

like to install the controller. The closer the survey tool

is to the actual installation location of the controller,

the more accurate the survey results

will be.

• DoNOTstanddirectlyinbetween2surveytools

while measuring. Your body will interfere with

transmission signals. Always stand out of line of sight

to avoid interfering with the signal readings.

• Toinsureaccuratereadings,ALWAYS hold the tools

by the bottom using the battery holder (g. 6). Do

not hold it by the controller case, as you may cover

the antenna (fig. 7).

Important Notes About The Survey Tools:

• Thesurveytoolsfeatureanauto-shutdownafter

10 minutes. After 10 minutes, 10 quick audio beeps

will be heard; if the ON button is not re-pressed, the

unit after the count of 10 beeps, the unit will self

shutdown to prevent unnecessary battery drainage.

• Theminimalexpectedbatterylifeisatleast50full

chargecycles.Themaximumexpectedbatterylifeis

200 full charge cycles.

• ContactViconicsforreplacementbatteries.The

survey tools use a custom rechargeable battery

type. DO NOT USE regular rechargeable batteries for

replacement; the charging circuit is NOT DESIGNED

forthat.DoingsoMAYresultincriticalfailureand/

or injury.

Site Survey Overview

If available, it is best to have a oor plan layout showing

the location of all the proposed controllers to be

installed.

If possible, perform the survey during occupied hours

where other electronic devices such as (computers,

wireless laptop, cell phones, PDA’s, wireless telephones,

microwave ovens, light ballasts, etc.) would be in use as

to generate as much interference as possible.

Some of these devices can generate interference up to

20 feet or 6.8 meters away during normal operation. Even

with possible sources of signal interference, the presence

of these wireless devices will most probably not result in

any network performance degradation.

It is important to understand that the survey values given

by the survey tool are provided as a worst case scenario

of a point to point application.

Once the whole is deployed with a Jace and VWG

coordinator and all wireless controllers are present and

functioning as routers, the ability of the network to

eciently route wireless signals cannot be compared to

this simple survey analysis method. Thus, it is important

to remember that the displayed percent signal ONLY

represents the signal strength from point A to point B.

As other devices join the network mesh, the route taken

from device A to device B will most likely change.

A dense cluster of wireless controllers will allow your

network to recover from temporary disturbances more

swiftly.

To ensure a proper survey, Viconics

recommends using ONLY channels 15 or 25 to

avoid network interference with 802.11 Wi-Fi

devicesinthe2.4GHzspectrumrange.Begin

bysettingBOTHdevicestotheSAMEchannel

& PAN ID.

Before starting a site survey:

• Presstheonbuttononbothdeviceswhileholding

them side by side.

• 100%signalstrengthindicatesthatthesurveytools

are functioning properly.

Survey Considerations:

• Alwaysholdthesurveydeviceverticallytoinsure

proper measurements. The controllers antenna

Fig. 6

Fig. 7

1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários

Viconics VST5000 (Classic ZigBee) User Guide Manual do Utilizador Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Para a casa Viconics VST5000 (Classic ZigBee) User Guide